| A. 1x Hemera extruder | F. 1x HeaterCore Sock |
| B. 1x 4010 fan | G. 1x Revo Nozzle |
| C. 2x Self-tapping screws | H. 1x Thermistor extension cable |
| D. 1x Spring | I. 1x Fan extension cable |
| E. 1x HeaterCore | J. 1x Heater extension cable |
Assembly Steps:
1. Attach the spring to the groove on the bottom of the Heatsink.
2. Attach the HeaterCore to the Hemera and spring assembly.
3. Screw in the Nozzle, it should slide freely through the HeaterCore.
4. Attach the fan to the Hemera HeatSink using the self-tapping screws.
The colour of the HeaterCore thermistor wire has recently changed from white to blue. If your HeaterCore has a white thermistor cable. Please refer to the diagram below.
5. Attach the HotEnd extension cables.