| A. 1x Hemera XS extruder | F. 1x Revo Nozzle |
| B. 1x 4010 fan | G. 1x Thermistor extension cable |
| C. 2x Self-tapping screws | H. 1x Fan extension cable |
| D. 1x Spring | I. 1x Heater extension cable |
| E. 1x HeaterCore |
Assembly Steps:
1. Attach the spring to the groove on the bottom of the Heatsink.
2. Attach the HeaterCore to the Hemera and spring assembly.
A slight twisting motion may be required.
3. Screw in the Nozzle, it should slide freely through the HeaterCore.
4. Attach the fan to the Hemera HeatSink using the self-tapping screws.
The colour of the HeaterCore thermistor wire has recently changed from white to blue. If your HeaterCore has a white thermistor cable. Please refer to the diagram below.
5. Attach the HotEnd extension cables.