Summary
- Max Printing Temperature: 300°C
- Mass: ~53g
- Temperature sensor type: thermistor, Semitec 104NT-4-R025H42G
- Voltage options: 12V or 24V
- Wattage: 40W
- Filament diameter: 1.75mm
Volume and Dimensions
Power vs Temperature
Initial Resistance of a 24V heater at 23°C: 14.4Ω
Temp Coefficient of HeaterCore: 0.002078
Temp Coefficient of Heater Cartridge: 0.002078
Mounting Guidance
Mounting type: E3D Groove Mount
Cable Orientation
Turn Revo HeaterCore anti-clockwise to orient cables. Turning clockwise will cause the
spring to disengage.
Assembly
There is no need to hot-tighten the Revo Six assembly. Tools must not be used to fasten
the Revo Nozzle to the HeaterCore.
Operational Temperatures
Maximum recommended ambient operating temperature (PLA): 40°C
Lowest temperature rated component: Fan 70°C
Electrical Specification
Fan
12V or 24V
Fan current: 0.1A (12V) and 0.08A (24V)
Heater
12V or 24V, 40W nominal power at ambient
Fan noise: 30 dB(A)
Temperature
Temperature sensor: Semitec 104NT-4-R025H42G
Connections
Fan: Molex SL, 2 Pin, Unpolarised
Heater: Molex Micro-Fit 3.0, 2 pin horizontal
Temperature sensor: Molex Micro-Fit 3.0, 2 pin horizontal
Assembly is supplied with 1m cables to connect to mainboard
Materials
Heatsink: Aluminium (black anodised)
HeaterCore: Alumina, Bronze
Fan Shroud: Polycarbonate
Compliance
Reach
RoHS
WEEE
Exploded View
| 1. 4x Self-Tapping Screws | 7. Revo spring |
| 2. 3010 fan | 8. Revo HeaterCore |
| 3. Fan duct | 9. Revo HeaterCore sock |
| 4. Collet clip | 10. Revo Nozzle |
| 5. Collet | 11. Revo Nozzle sock |
| 6. Heatsink |
Changelog
Edition 4
Approved: RY 19/07/22
Published: 19/07/22
Notes: Migrated PDF to Zendesk, Power vs Temperature graph added and minor phrasing changes
Edition 3
Approved: DR 07/01/22
Published: 17/01/22
Notes: Operating temperature updated
Edition 2
Approved: DR 07/12/21
Published: 07/12/21
Notes: Flow rate units changed to mm³/sec
Edition 1
Approved: RY 01/11/21
Published: 03/11/21
