Summary
- Max printing temperature: 300°C
- Mass: ~30g
- Temperature sensor type: Creality thermistor
- Voltage options: 12V or 24V
- Wattage: 40W
- Filament diameter: 1.75mm
Volume and Dimensions
Mounting Guidance
Mounting type: M3 x 0.5
The screws from your existing Creality HotEnd can be used to mount Revo CR.
Cable Orientation
Turn Revo HeaterCore anti-clockwise to orient cables. Turning clockwise will cause the
spring to disengage
Assembly
There is no need to hot-tighten the Revo CR assembly. Tools must not be used to fasten
the Revo Nozzle to the HeaterCore
Operational Temperature
Maximum recommended operating temperature (PLA): 40°C
Connections
Heater: Molex Micro-Fit 3.0, 2 pin horizontal
Temperature sensor: Molex Micro-Fit 3.0, 2 pin horizontal
Materials
Heatsink: Aluminium (black anodised)
HeaterCore: Aluminia, Bronze
Assembly is supplied with 1m cables to connect to mainboard
Electrical Specification
Heater: 12V or 24V, 40W nominal power at ambient
Temperature sensor: Creality Thermistor
Power vs Temperature
Initial Resistance of a 24V heater at 23°C: 14.4Ω
Temp Coefficient of HeaterCore: 0.002078
Temp Coefficient of Heater Cartridge: 0.002078
Compliance
Reach
RoHS
WEEE
Exploded View
| 1. Collet | 5. Revo HeaterCore |
| 2. Collet Clip | 6. Revo HeaterCore Sock |
| 3. Revo CR Sink | 7. Revo Nozzle |
| 4. Revo Spring | 8. Revo Nozzle Sock |
Changelog
Edition 2
Approved: RY 19/07/2022
Published: 19/07/2022
Notes: Migrated PDF to Zendesk
Edition 1
Approved: RY 03/03/2022
Published: 03/03/2022 