Summary
- Max Printing Temperature: 300°C
- Mass: ~25g
- Temperature sensor type: thermistor, Semitec 104NT-4-R025H42G
- Voltage options: 12V or 24V
- Wattage: 40W
- Filament diameter: 1.75mm
Volume and Dimensions
Mounting Guidance
Mounting type: M3 x 0.5
Complete mounting instructions and STL files for the Voron printed parts can be found at VoronDesign.com
Cable Orientation
Turn Revo HeaterCore anti-clockwise to orient cables. Turning clockwise will cause the spring
to disengage.
Assembly
There is no need to hot-tighten the Revo Voron assembly. Tools must not be used to fasten
the Revo Nozzle to the HeaterCore.
Operational Temperatures
Maximum recommended ambient operating temperature (PLA): 40°C
Connections
Heater: Molex Micro-Fit 3.0, 2 pin horizontal
Temperature sensor: Molex Micro-Fit 3.0, 2 pin horizontal
Assembly is supplied with 1m cables to connect to mainboard
Materials
Heatsink: Aluminium (red anodised)
HeaterCore: Alumina, Bronze
Electrical Specification
Heater: 12V or 24V, 40W nominal power at ambient
Temperature sensor: Semitec 104NT-4-R025H42G
Power vs Temperature
Initial Resistance of a 24V heater at 23°C: 14.4Ω
Temp Coefficient of HeaterCore: 0.002078
Temp Coefficient of Heater Cartridge: 0.002078
Compliance
Reach
RoHS
WEEE
Exploded View
| 1. Revo Voron sink | 4. Revo HeaterCore sock |
| 2. Revo spring | 5. Revo Nozzle |
| 3. Revo HeaterCore | 6. Revo Nozzle sock |
Changelog
Edition 2
Approved: RY 19/07/2022
Published: 19/07/2022
Notes: Migrated PDF to Zendesk and minor phrasing changes
Edition 1
Approved: RY 03/03/2022
Published: 03/03/2022
